Joecoral
Member
Just received my Eth300 today, and I just wanted to confirm which way you need to turn the blue bits to hold the hose in place
I assume you start off with the blue bits nearest the heater itself, push the hose on, then "unscrew" them so they move down over the hose, assuming holding it in place. I only ask as this seems a little counter-intuitive
In other words, like in my diagram, push hose on THEN turn blue bits so they move in the direction of the arrow?
Thanks
JC
I assume you start off with the blue bits nearest the heater itself, push the hose on, then "unscrew" them so they move down over the hose, assuming holding it in place. I only ask as this seems a little counter-intuitive
In other words, like in my diagram, push hose on THEN turn blue bits so they move in the direction of the arrow?
Thanks
JC