pepedopolous
Member
Hi there.
I'm not much of a DIY person and I'm planning to get a NA setup with a stainless steel rail to hang the light from.
I haven't settled on a light yet but the hanging kits on the market seem to be only for ceilings.
So what I need is a way to make a secure fixed loop in a cable which I can then slide over the rail. It must cope with the weight of the light which can be up to 2.5 kilos (though there will probably be 2 cables).
Is it safe to simply use a crimp sleeve and pliers to make the loop?
I've found this website which has some other solutions but the cable might be too thin for them...
http://www.sign-holders.co.uk/Sign-fixings/Hanging-wire-systems/Wire-rope-fittings/c-1-44-151-158/
Many thanks,
P
I'm not much of a DIY person and I'm planning to get a NA setup with a stainless steel rail to hang the light from.
I haven't settled on a light yet but the hanging kits on the market seem to be only for ceilings.
So what I need is a way to make a secure fixed loop in a cable which I can then slide over the rail. It must cope with the weight of the light which can be up to 2.5 kilos (though there will probably be 2 cables).
Is it safe to simply use a crimp sleeve and pliers to make the loop?
I've found this website which has some other solutions but the cable might be too thin for them...
http://www.sign-holders.co.uk/Sign-fixings/Hanging-wire-systems/Wire-rope-fittings/c-1-44-151-158/
Many thanks,
P