Hi There,
I had to remove my CO2 diffuser and tubing during some tank maintenance, and now since I've re-connnected it I cannot get CO2 to run again, when I open the fine valve I get a few bubbles appearing in the diffuser and then nothing. I've checked the tubing and there's no blockages, I've checked the Diffuser and it's 3/4 full of tank water as per the instructions and no blockages, if I remove the tubing from the CO2 unit I get a small amount of pressure release and some fluid ? CO2 is definetely been released from the unit as I can hear it without the tubing attached. Any idea's what the problem could be ?
I had to remove my CO2 diffuser and tubing during some tank maintenance, and now since I've re-connnected it I cannot get CO2 to run again, when I open the fine valve I get a few bubbles appearing in the diffuser and then nothing. I've checked the tubing and there's no blockages, I've checked the Diffuser and it's 3/4 full of tank water as per the instructions and no blockages, if I remove the tubing from the CO2 unit I get a small amount of pressure release and some fluid ? CO2 is definetely been released from the unit as I can hear it without the tubing attached. Any idea's what the problem could be ?