Changing co2 FE

Discussion in 'Carbon Dioxide (CO2)' started by jym, 18 Feb 2010.

  1. jym

    jym Member

    Joined:
    4 Jun 2009
    Messages:
    31
    Location:
    West Sussex
    Hi, I will soon need to change my co2 FE for a full one.
    Can someone give me precise instructions, step by step on how to do this.
    It is probably easy, but this is my first changeover and I feel nervous lol.
     
  2. jonnyjr

    jonnyjr Member

    Joined:
    22 Aug 2009
    Messages:
    114
    It is just a case of releasing the handle on the FE so it is in the closed position. Then unscrewing the nut for the regulator. You should replace the sealing washer between the reg and new FE then tighten it up as before and squeeze the handle down checking for no leaks.
     
  3. jym

    jym Member

    Joined:
    4 Jun 2009
    Messages:
    31
    Location:
    West Sussex
    Thank you for your reply jonnjr. Where can I get replacement sealing washers?
     
  4. jonnyjr

    jonnyjr Member

    Joined:
    22 Aug 2009
    Messages:
    114
    The new washer is just a precaution as I get mine form a pub supplier I'm not sure where you could get yours. All it should need is a firm tighten, other members may know where to get it from though.

    Jon
     
  5. chris1004

    chris1004 Member

    Joined:
    27 Dec 2008
    Messages:
    565
    Hi Jym,

    I think it largly depends on the regulator set that you are using. Can you link us to a picture of the one you have and I'm sure there will be someone else on here using the same setup that can tell you for sure?

    Regards, Chris.
     

Share This Page

Facebook Page
Twitter Page
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice