mede
Member
I'm using the spray-bar vertically placed in my 60x30x35cm tank and the filter I'm using is a TetraTec EX600 (600l/h)...... (is it better to convert my measurement units to UK units??)...
There is a good flow to the other side of the tank where the flow from the spray-bar clashes to the window, moving the flow downwards through the tank back to the spray-bar side.
The only thing that I notice is that 1/4 FROM the outflow the flow is much less then 3/4 from the clashed window back to the window side where the spray-bar is placed.
(hope this is clear enough)...
I was thinking of drilling a few extra holes into the bottom of my spray-bar (downwards outflow) so that there's also a little more flow on the spot under the spray-bar (the 1/4 part with less flow) - good idea, or....?
Any advise on my thoughts?
There is a good flow to the other side of the tank where the flow from the spray-bar clashes to the window, moving the flow downwards through the tank back to the spray-bar side.
The only thing that I notice is that 1/4 FROM the outflow the flow is much less then 3/4 from the clashed window back to the window side where the spray-bar is placed.
(hope this is clear enough)...
I was thinking of drilling a few extra holes into the bottom of my spray-bar (downwards outflow) so that there's also a little more flow on the spot under the spray-bar (the 1/4 part with less flow) - good idea, or....?
Any advise on my thoughts?