Stewartandersonuk
Member
Full details on my tank and equipment are located here viewtopic.php?f=35&t=6193 if you should need them.
I am using an external Aquamedic 1000 reactor with Fire Extinguisher
1, I can get the bubble checker set to something like 1 bubble per second and 95% of the time it comes out as really fine bubbles from out the spray bar (I assume this is fine)?
2, If I try and increase to 3 bubbles per second (I think what everyone else uses) only 40% is fine bubbles and the rest are larger is this wrong? it also sounds quite loud, what can I do to improve this?
3, using either of the above I can see all over my tank very fine co2 bubbles in the water, I have a pump slightly to the left under the co2 outlet spray bar which gets them to the other end of tank. However unless my drop checker is near the spray bar I can not get it to change to yellow(tank is empty, checking co2 is getting all over tank). Given my tank is so long 5 foot should I consider moving my co2 spary bar to the centre?
Once I get this nailed down I think I will be all set
I am using an external Aquamedic 1000 reactor with Fire Extinguisher
1, I can get the bubble checker set to something like 1 bubble per second and 95% of the time it comes out as really fine bubbles from out the spray bar (I assume this is fine)?
2, If I try and increase to 3 bubbles per second (I think what everyone else uses) only 40% is fine bubbles and the rest are larger is this wrong? it also sounds quite loud, what can I do to improve this?
3, using either of the above I can see all over my tank very fine co2 bubbles in the water, I have a pump slightly to the left under the co2 outlet spray bar which gets them to the other end of tank. However unless my drop checker is near the spray bar I can not get it to change to yellow(tank is empty, checking co2 is getting all over tank). Given my tank is so long 5 foot should I consider moving my co2 spary bar to the centre?
Once I get this nailed down I think I will be all set