Hi All
The fittings on my Yidao reactor that are supposed to screw up over the pipes to keep them secure are loose and doing virtually nothing to secure the pipes, they just spin straight over the the top of them.
I’ve found that the pipes will pretty much hold themselves but did get the tiniest seep on testing which makes me a little nervous.
Anyone had the same issue and how did you solve it?
I’ve tried out a fitting from my OASE filter just to see if that would work but it’s a different thread size so won’t fit.
A bit of electrical tape around the bottom of the pipe solved the seep and tightened the fitting somewhat but I’m not convinced that this ‘custom mod’ (aka bodge) is really the way forward!! 😏 😂
Suggestions?
The fittings on my Yidao reactor that are supposed to screw up over the pipes to keep them secure are loose and doing virtually nothing to secure the pipes, they just spin straight over the the top of them.
I’ve found that the pipes will pretty much hold themselves but did get the tiniest seep on testing which makes me a little nervous.
Anyone had the same issue and how did you solve it?
I’ve tried out a fitting from my OASE filter just to see if that would work but it’s a different thread size so won’t fit.
A bit of electrical tape around the bottom of the pipe solved the seep and tightened the fitting somewhat but I’m not convinced that this ‘custom mod’ (aka bodge) is really the way forward!! 😏 😂
Suggestions?