matty_
New Member
Hello all, I have an issue which I'm not too sure of the cause particularly. I thought it was a leak at first so to eliminate this I ran the CO2 tube directly to the tank from the needle valve.
I start with 30PSI working pressure at 2bps, this can run all day long without any stability issues, but once the solenoid turns off for the day the pressure rises about 2psi roughly. The issue starts once the solenoid is turned on the next day (the working pressure is still 30psi before it is switched on in the morning) the working pressure drops from 30psi to 0 and doesn't regain the pressure back unless I manually add more working pressure with the middle knob.
Hope someone could help out, I have started contact with CO2Art about this also.
Regards,
Matt
I start with 30PSI working pressure at 2bps, this can run all day long without any stability issues, but once the solenoid turns off for the day the pressure rises about 2psi roughly. The issue starts once the solenoid is turned on the next day (the working pressure is still 30psi before it is switched on in the morning) the working pressure drops from 30psi to 0 and doesn't regain the pressure back unless I manually add more working pressure with the middle knob.
Hope someone could help out, I have started contact with CO2Art about this also.
Regards,
Matt