dean
Member
Hi all I’m putting a spray bar on my trigon 350 it will be situated along the front curved glass
Making it from plumbsure 15mm pushfit pipe
The pump is an Eheim compact + 3000
Set on its highest at 3000 litres per hour
I know the 15mm pipe is too small for the pump but it fits below the braces and above the water level so only bits of the fittings will show in the water which I can live with for now
The pump is situated in the rear corner
The spray bar with make a complete loop around the tank so pressure is evenly spread
I need help with working out how many holes and what diameter they need to be so I just get a gentle flow down the front glass and not a high pressure jet that will cut fish in half
The actual spray bar part is approximately 1300mm long
Sent from my iPhone using Tapatalk
Making it from plumbsure 15mm pushfit pipe
The pump is an Eheim compact + 3000
Set on its highest at 3000 litres per hour
I know the 15mm pipe is too small for the pump but it fits below the braces and above the water level so only bits of the fittings will show in the water which I can live with for now
The pump is situated in the rear corner
The spray bar with make a complete loop around the tank so pressure is evenly spread
I need help with working out how many holes and what diameter they need to be so I just get a gentle flow down the front glass and not a high pressure jet that will cut fish in half
The actual spray bar part is approximately 1300mm long
Sent from my iPhone using Tapatalk