Bertie
Member
- Joined
- 18 Apr 2013
- Messages
- 489
Hi,
How do everyone make sure they have a straight line of holes on their diy spray bars?
I have very limited tools.
I have just ordered more pipe to make more spraybars as the ones I made a few months ago have about 4/5 holes out of line so makes it difficult to raise the bar above a certain level else the surface of the water gets broken.
With my last diy bars I found a straight upright (checked with my level) but the tubing was obviously bent so a few holes were out of line.
I was thinking of getting a chalk line or even making a plumb bob with string and a heavy bolt or nut and getting some chalk dust from B&Q or similar but knowing how clumsy I am I would probably rub the chalk off before marking the holes off
Any hints or tips would be welcome.
How do everyone make sure they have a straight line of holes on their diy spray bars?
I have very limited tools.
I have just ordered more pipe to make more spraybars as the ones I made a few months ago have about 4/5 holes out of line so makes it difficult to raise the bar above a certain level else the surface of the water gets broken.
With my last diy bars I found a straight upright (checked with my level) but the tubing was obviously bent so a few holes were out of line.
I was thinking of getting a chalk line or even making a plumb bob with string and a heavy bolt or nut and getting some chalk dust from B&Q or similar but knowing how clumsy I am I would probably rub the chalk off before marking the holes off
Any hints or tips would be welcome.