Hi All
Propigator is all setup and has been running for about a week. The setup was slightly different to planned. I put in an Anubias nana in to check it was okay and it's growing really well.
Anubias stardust only went in today. (fingers crossed and toes crossed)
Now it's all working I need to build a nice cabinet and light stand for it.
The humidity sits at 100% but I still want to add a misting system I'm currently spraying by hand 3x a day, I bought a cheap humidifier but haven't manage to bypass the capacitive switch to allow me to run it from a timer, I've then got to work out how to plum it in, I doubt the fan will like being in a loop.
I'm still 50/50 about switching to high pressure pump and a spray nozzle. I was as looking at the following but not a clue how to connect it up, or how many nozzles I need?
63l/h micro irrigation spray nozzle
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/150828976629
12V 130PSI 6L/Min Water Pump
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/192587571758
Will 6mm pvc tubing take 130psi?
Heres a photo of the plants
Pump is set on a timer 15mins on fill / 15mins off drain cycle, this ebb and flow setup ensures a really good flow of nutrients to the roots, keeping them moist and aerated. The level is limited my a large drain in the centre.
I went for 2 x 20w floodlight if it was too bright I can always turn one off.
Thanks for all the tips and advice
Ps I've also added some Canna Rhizotonic rooting compound, does everyone dose at the recommended 1:250?