Ehiem External - where to fit hermetic seals?

Discussion in 'Hardware & DIY' started by Woodpecker, 19 Jun 2009.

  1. Woodpecker

    Woodpecker Newly Registered

    Messages:
    18
    Hi,

    Looking for some help with an ehiem 2222 pro external filter.

    Most of the rubber seals on my second hand filter have gone hard & I am going to replace them before I put it into use.

    I now have a new pack of 3 "hermetic seals" part 7343390 but according to the parts diagram I can only see where 2 of them go - namely on top of the pipes in the 2 media baskets. Where does the third seal go, or is it just a spare (not like Eheim though! So I'm concerned) :?:

    Many thanks,
    Sue
     
  2. TDI-line

    TDI-line Member

    Messages:
    1,535
    Location:
    Yaxley, Peterborough
    Not to sure in your model, but how many trays do have for putting media in?
     
  3. TDI-line

    TDI-line Member

    Messages:
    1,535
    Location:
    Yaxley, Peterborough
  4. Woodpecker

    Woodpecker Newly Registered

    Messages:
    18
    Brilliant, thanks Dan! The simple answers are always the best!

    Sue :D
     

Share This Page

Facebook Page
Twitter Page
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice