lordingsy said:
stevec said:
if you take off the hose connector completly from the reg by unscrewing it and then remove the srew on cap from the needle valve will it screw into the reg? thats how i would try to set it up
I've tried this already. Was going to remove where the reg meets the the hose but my word its in there very very very well. Must have about half a gallon of loctite on it or something. Will not move at all.
The thing is I do think this will solve the problem if I can remove it.
Hi,
I don't mean to be raining on your parade here when I say this but you really should be aware just how dangerous pressurized canisters can be. I for one certainly would be very careful about playing around with the fixtures and fittings if I were you.
I'm not familiar with the other co2 system you linked to it seems very expensive £77 so may have applications that it could be suitable for, unless of course its a total rip off bit of kit.
How big is your tank?
Regards, Chris.