Bartash
Member
If you want to add co2 to 2 tanks but only use 1 bottle i think this is a good way for you to achieve this
http://www.hosefit.co.uk/catalog/produc ... cts_id=267
http://www.hosefit.co.uk/catalog/produc ... cts_id=297
put the Y connector first then one of the inline flow controllers on both lines this will allow you to control the bubble rate better for each tank
If you just want to control the flow rate for 1 line then you can use this instead of a normal pin adapter that screws into the bottom of your regulator
http://www.hosefit.co.uk/catalog/produc ... cts_id=778
i hope this helps some people out
Carl
http://www.hosefit.co.uk/catalog/produc ... cts_id=267
http://www.hosefit.co.uk/catalog/produc ... cts_id=297
put the Y connector first then one of the inline flow controllers on both lines this will allow you to control the bubble rate better for each tank
If you just want to control the flow rate for 1 line then you can use this instead of a normal pin adapter that screws into the bottom of your regulator
http://www.hosefit.co.uk/catalog/produc ... cts_id=778
i hope this helps some people out
Carl