Johnzz
Seedling
foxfish said:Anyone using one of these?
I installed one a few weeks back, it seemed to need a lot of pressure to get going but worked very well in deed - however I have to keep adjusting my needle valve to keep it consistent.
I assume the device is getting clogged but how do you clean it?
I installed mine last week.
My JBL ProFloral regulator is pre-set to 1.5 bars, which I don't think is sufficient. I also had problems initially setting the CO2 flow.
When first set up, I had the fine mist coming out. However the next day, after the solenoid turned off and on again, it no longer produced the mist (i.e. not enough pressure to push back through the membrane). I had to open my fine needle valve even more (almost full blast) just to get the mist to remain constant after turning off and on again.
It's now working fine, but I’m looking to manually adjust the regulators pressure to 3 bars (if I can figure out how… lol).
I also had the JBL bubble counter, but it just couldn’t cope with the higher pressure, so I had to ditch it.