Nick potts
Member
I have just set up a new co2 system.
It's pretty basic and goes sodastream>reg>check valve>needle valve and bubble counter>diffuser.
The tank pressure is around 900psi and output set at 5 bar.
The setup doesn't have a solenoid but I turn it on/off via the SodaStream adapter, leaving the needle valve and regulator valves alone, it was working fine when I set it up yesterday at 2bps, turned it off last night and when I come to turn it on this afternoon is am unable to get any more than about 1bps no matter how much I open the needle valve.
I have check pressure, taken it all apart and tested all individual bits are working etc.
Anyone else experience anything similar and can throw some suggestions my way.
Cheers
It's pretty basic and goes sodastream>reg>check valve>needle valve and bubble counter>diffuser.
The tank pressure is around 900psi and output set at 5 bar.
The setup doesn't have a solenoid but I turn it on/off via the SodaStream adapter, leaving the needle valve and regulator valves alone, it was working fine when I set it up yesterday at 2bps, turned it off last night and when I come to turn it on this afternoon is am unable to get any more than about 1bps no matter how much I open the needle valve.
I have check pressure, taken it all apart and tested all individual bits are working etc.
Anyone else experience anything similar and can throw some suggestions my way.
Cheers