ExcitableBoy
Member
Hi,
I don't know if others have the same problem, but I can't manage to keep a consistent flow rate of bubbles(which is high). I set it at "x" speed, but when the CO2 turns on the day after the flow is slower.
The problem is worse the day after refilling the bubble counters, and I have to do it weekly.
I am thinking to replace the needle valves with other brands, but I need to keep the two outputs.
Do you suggest to remove both the manifold blocks and use another CO2 splitter or could I leave them? In the second case I would leave the CO2 arts needle valves fully open and I'd place the new needle valves between them and the bubble counters. But it could be a stupid solution I don't know honestly.
Do you know some good needle valves?
I have found this one
Camozzi RFO 382 1/8
I don't know if others have the same problem, but I can't manage to keep a consistent flow rate of bubbles(which is high). I set it at "x" speed, but when the CO2 turns on the day after the flow is slower.
The problem is worse the day after refilling the bubble counters, and I have to do it weekly.
I am thinking to replace the needle valves with other brands, but I need to keep the two outputs.
Do you suggest to remove both the manifold blocks and use another CO2 splitter or could I leave them? In the second case I would leave the CO2 arts needle valves fully open and I'd place the new needle valves between them and the bubble counters. But it could be a stupid solution I don't know honestly.
Do you know some good needle valves?
I have found this one
Camozzi RFO 382 1/8