Bobtastic
Member
Hi all,
I'm looking to get hold of a Aqua Media 1000 Co2 reactor and was wondering if anyone on here has had any experience it connecting the hoses to the reactor. I've seen pictures of one that uses the rubber ends on the hoses, but i can't tell if they are the ends that fit into the filter or the rubber "cap" ends... If they are then that would mean using the full length of replacement (spare) hose to go from the filter to the reactor and then the same length again from the reactor to the outlet. Would this not affect the flow?
Or is there another way of connecting it all up? If anyone has picture of how they've done this it would be most helpful.
Thanks in advance!
I'm looking to get hold of a Aqua Media 1000 Co2 reactor and was wondering if anyone on here has had any experience it connecting the hoses to the reactor. I've seen pictures of one that uses the rubber ends on the hoses, but i can't tell if they are the ends that fit into the filter or the rubber "cap" ends... If they are then that would mean using the full length of replacement (spare) hose to go from the filter to the reactor and then the same length again from the reactor to the outlet. Would this not affect the flow?
Or is there another way of connecting it all up? If anyone has picture of how they've done this it would be most helpful.
Thanks in advance!