I have been reading the tutorial on using fire extinguishers and I got lost when reading the section on "firing the fe". How do I do this step? searching the forums/net was fruitless.
I am assuming that "firing the fe" could be as simple as pressing/squeezing the levers. but since the term "fire the fe" was used, I'm not so sure if my understanding is right.
off-topic questions
1. How do I checked for leaks if the solenoid is built into the regulator?
2. The tank that I got has lots of teflon tape to seal the nozzle. Do you think I need teflon tape as well? I know that in the FE tutorial, several people has mentioned not to use teflon tape as it prevent the O-ring from doing its job.
Thank you very much
I am assuming that "firing the fe" could be as simple as pressing/squeezing the levers. but since the term "fire the fe" was used, I'm not so sure if my understanding is right.
off-topic questions
1. How do I checked for leaks if the solenoid is built into the regulator?
2. The tank that I got has lots of teflon tape to seal the nozzle. Do you think I need teflon tape as well? I know that in the FE tutorial, several people has mentioned not to use teflon tape as it prevent the O-ring from doing its job.
Thank you very much