mdhardy01 said:
Do you know if there is any way of turning
up the output pressure on this reg?
The output pressure can be altered by rotating the adjustment screw, rotate the screw clockwise (winding the screw in) will increase the pressure at the gauge (right hand side gauge) which will decrease the line pressure - less bps
but the right hand gauge will show a high pressure , rotate the screw anti clockwise decrease the gauge pressure which will increase the line pressure - more bps
but the gauge will show a lesser pressure . All the screws does is to allow you to increase / decrease the amount of bps. The screw in question is circled in red on the attached picy.
The purpose of the needle valve is to restrict the volume of low pressure travelling down the Co2 tubing - the more restriction at the needle value a higher low pressure will be seen on the gauge.
E.g 6 bps may show a gauge pressure (right hand dial) of 1.0 bar, 2 bps may show a gauge pressure of 2.0 bar (right hand dial)
Regards
Paul.